Current list of speaker assignment for eMOTION sound decoders (german only) Date: 03. April 2020
Sorry, this entry is only available in German.
Sorry, this entry is only available in German.
Sorry, this entry is only available in German.
As always the question arises, how to digitize a Ge 4/4 III with pantograph control, enclosed in the picture the necessary additional parts: 1 x Onboardadapter 8150701 1 x SUSI – LGB Onboard 4-wire 200mm 8312075 1 x Special Adapter cable 1 wire as shown in the picture. In case of need you can also cut the plug and connect the 1 cable as shown in the picture to…
Enclosed is the connection diagram of the Massoth LS decoder and the 10-pin DCC interface. LS_an_DCC_Schnittstelle.pdf
The maximum length of the bus cable depends on the cable used! For a non-shielded telephone cable, it is a maximum of 20m. For a CAT 5 or CAT 6 cable the length is almost unlimited. Whereupon a special bus amplifier is needed.
Connection of the Reverse loop module in an oval.
Stop in a single siding track As an example for a train stop in a single siding track or station. Additionally on pull in or out the bell will start from the decoder Note: In this example we use a signal, that doesn’t exist. You don’t need a signal to use the functions! Please program the IR-Sender as follows: CV 32 = 5 (Address of the signal) CV 41 =…
Simple Shuttle operation with two stops As an example we will describe here a simple shuttle operation with two end points. The locos will stop in the station and will start after a fixed time. Please program the IR-Sender 1 as follows: CV 32 = 1 (Address of the signal) CV 41 = 5 (Automatic) CV 42 = 4 (Shuttle forward) CV 45 = 15 (15 Sec. stop) Activate it…
Deutsch
