You can also connect a XL/XLS Decoder to a Brawa Interface. Therefore you need two 9-pole plug connectors. Connect them like described below. Following special functions of the loco are usable. Light : Swiss illumination (3+1) in both directions. F1 : Light cabin F2 : Shunting lights (3+3) F3 : Smoke unit (CV115=3 parallel output F4 on key 3) Because of the higher amperage of the smoke unit F3+F4 are connected parallel. Alternatively,…
Attached you can find a plan howto connect a L decoder at a LGB interface cable.
If you have old 3-pin Switch-drives from LGB, you can control this with our 4 channel-switching decoders. Here is a sketch how to connect it: The switching time should be set down a little in CV 51-58 (Value 66).
Sorry, this entry is only available in German.
With transistors, the function outputs F5-F8 can be operated with a higher current. Here is an example of the XLS. The polarity of a resistor (1KOhm) does not matter. The polarity of the transistor must be observed!
Here we will explain how to realize a Ditchlight. A Ditchlight are 2 lights of the front light, which blink alternately when operating bell / horn. Here the circuit for a Ditchlight. The values of the resistors have to be adjusted. The following CVs have to be programmed using a XLS and when triggering the Ditchlights should take place on key 1: CV 113=1 (A3 at Key 1) CV…
Deutsch
